Tennis Court Maintenance
Court Maintenance Guidelines
The Club has made a major investment in the new courts, and it’s important that we all work together to keep them in excellent condition. Proper care ensures a great playing surface that will last for years to come.
🎾 Artificial Clay Courts (Courts 4 & 7)
These courts consist of a carpet layer with a loose sand dressing. If the carpet fibres are exposed, the surface will be damaged and the life of the courts reduced.
Brushing the Courts
-
Each court has two drag-nets and one line brush
-
Players should use the drag-nets after each session – please use the last few minutes of your booking for this
-
Don’t forget the areas behind the baseline, which wear down faster
-
The preferred method is a spiral pattern, starting from the back and working inward to the service line “T”
-
Guidelines are displayed outside each court entrance, and a short video is available HERE for demonstration
Line Brushing
-
After dragging, run the line brush lightly down each line
-
Avoid pressing too hard — the goal is to remove excess sand, not gouge the surface
Keeping Sand on the Courts
-
Use the shoe brushes and mats at each court entrance to remove sand before leaving
-
Be extra careful when moving between clay and artificial grass courts
-
Gates between courts 6 & 7 and 4 & 5 are locked to reduce sand transfer
-
An additional brush is installed outside court 3 for extra precaution
🌱 Artificial Grass Courts (Courts 1–3, 5 & 6)
These courts require minimal maintenance from members:
-
Enter carefully, avoiding dirt or clay sand residue
-
If coming from clay courts, clean shoes thoroughly before entering
-
Report any issues (e.g., holes in nets) to the Tennis Committee
-
On ALL courts, both artificial grass and artificial clay, always lower the net after play to extend its lifespan
🛠️ Club Maintenance
-
Weekly: Ground staff carry out heavier brushing and redistribute sand around the courts
-
Annual: A specialist company performs deep infill penetration to improve drainage and compaction
-
Additional sand is added if levels are too low after brushing
